Campbell, CA, July 7, 2020 – Ricoh Electronic Devices Co., Ltd. in Japan has launched two advanced PMIC for industrial and consumer purposes. These ICs are a single chip solution and provides four high-efficiency step-down DC/DC converters, seven low-dropout regulators, four GPIOs, an interrupt controller (INTC) and an I2C-Bus interface. The output voltages and the power-on/off sequence settings can be tailored in a profile and saved in a built-in One-Time Programmable (OTP) memory.
Ricoh has been developing mixed signal PMICs for over 20 years and are used in for example high-end mobile phones and tablets etc., making great contributions reducing power consumption, board space and is more cost efficient compared to a solution with individual power management ICs. A power supply for Application Processors, SoCs, FPGAs is often complex, meaning that an array of power management devices is required to provide power to all individual circuits. The easiest way to build an efficient power management system is to use a single IC that has all power control functions integrated.
The RN5T5610 is an industrial version suitable for continuous operation under wide operating temperature conditions whilst the RN5T5612 is designed for consumer applications. These PMICs include custom programmable features by OTP for initial output voltage setting and start-up/shut-down sequencing. A 2-wire I2C bus interface bus, operating at 400kHz or 3.4MHz, provides additional control by register settings such as turning individual output voltages on or off as well as adjusting the DC/DC converter and LDO output voltage levels by a Dynamic Voltage Scaling (DVS) feature. Step-rate for adjusting voltages is 50mV for OTP and 12.5mV for register settings.
These PMICs distinguishes On, Off and Sleep operating modes, the current consumption varies from Typical 13µA in Off-mode to maximum 440µA in On-mode depending on which outputs are enabled.
The four integrated Buck DC/DC Converters are able to provide 2x 2A and 2x 3A output current and have a peak efficiency level of 95%, all are operating with a 1µH inductor and 22µF output capacitor.
Five LDO regulators can be used for multipurpose and provide 3x 300mA and 2x 200mA, they have a fast-transient response, low output voltage noise and high ripple rejection ratio. Two additional LDO’s are always on but can be configured as always off as well when not used. One to power an RTC with a coin battery as a back-up power supply and also includes a reverse current protection. The other LDO is used for other purposes.
Target applications are an Industrial Controller Unit, PLC, Servo motor driver, a power supply for Application processor, SoC and FPGA, etcetera. The RN5T5610 and RN5T5612 are available in a QFN0707-48-P25 package and are identical products but differ in operating temperature range. A reference circuit is available to simplify the design of the power supply as well as a bill of material with recommended components. To achieve a maximum performance of the circuit, an example circuit board layout is available for your convenience. Samples and fully assembled + tested evaluation boards can be purchased from our authorized local distributors and online partners.
Features RN5T5610 / RN5T5612:
Operating Voltage Range (Maximum Rating) 2.7 to 5.5 V (6.0 V)
Operating Temperature Range RN5T5610 / RN5T5612 -40 to 105°C / -40 to 85°C
I2C-Bus interface 3.4 MHz and 400 kHz
Detector Function System/IO-Voltage-detector, UVLO, DETVSB
Thermal Shutdown Function
Power-on Key Input for System’s power up
Power-on Reset Output for CPU
Flexible Power-on/off Sequence by OTP
Flexible DCDCx and LDOx Default-on/off Control by OTP
High Efficiency Step-down DC/DC Converters:
DCDC1 / 2 0.6 to 3.5 V (Max. 3000 mA)
DCDC3 / 4 0.6 to 3.5 V (Max. 2000 mA)
Equipped with DVS and Power Save Mode (PSM)
LDO1 / 2 0.9 to 3.5 V (Max. 300 mA)
LDO3 0.6 to 3.5 V (Max. 300 mA)
LDO4 / 5 0.9 to 3.5 V (Max. 200 mA)
LDORTC1 (Always-on, for Coin battery) 1.2 to 3.5 V (Max. 30 mA)
LDORTC2 (Always-on) 0.9 to 3.5 V (Max. 10 mA)
Overcurrent Protection and Short-circuit Protection
Interrupt function (level/edge) for input signals
Power-on output signal for external devices
Power on/off input for System’s power up/down
Controllable DCDCx and LDOx by external input
LDORTC2 output via GPIO2 pin
Current Sink for LED via GPIO0/1 pins Max. 15 mA
32kHz output via GPIOx as a clock for external devices
Interrupt Controller (INTC)
Package QFN0707-48-P25 (0.5 mm pitch)
About Ricoh Electronic Devices Co., Ltd
Ricoh Electronic Devices Co., Ltd is a leading global provider of semiconductor products, offering a comprehensive portfolio of CMOS Power Management and Real Time Clock ICs that enable engineers to design advanced applications for the consumer, industrial and automotive markets. The company’s headquarter is based in Japan, as well as development, sales and manufacturing facilities. Regional sales and support offices are located in North America, Europe, and Asia.
Ricoh has an extensive expertise in small package technology and has a focus on developing products providing features such as low-supply current, high-accuracy, high efficiency and high-reliability.
For further information, please visit https://www.n-redc.co.jp/en/
| About Ricoh |
Ricoh is empowering digital workplaces using innovative technologies and services enabling individuals to work smarter. For more than 80 years, Ricoh has been driving innovation and is a leading provider of document management solutions, IT services, communications services, commercial and industrial printing, digital cameras, and industrial systems.
Headquartered in Tokyo, Ricoh Group operates in approximately 200 countries and regions. In the financial year ended March 2020, Ricoh Group had worldwide sales of 2,008 billion yen (approx. 18.5 billion USD).
For further information, please visit www.ricoh.com.
© 2020 Ricoh USA, Inc. All rights reserved. All referenced product names are the trademarks of their respective companies.
RICOH Americas Holding, Inc.
Electronic Devices Division
Tel: (408) 610-3105